Ensemble-designs BrightEye 3 Analog to SDI Converter with TBC and F User Manual download pdf (Page 7)

BrightEye-7

OPERATION

Control and operation of the BrightEye 3 converter is performed from the front

panel or with the BrightEye Control application.

Some control settings are only available with BrightEye PC or Mac. These parameters

cannot be monitored or controlled with the front panel.

Front Panel Controls and Indicators

The front panel of the converter, shown in the figure below, provides status indi-

cators and control over video input selection, TBC, and gain.

Status Indicators

The following status indicators are provided on the front panel:

Illuminates green when an input for the currently selected video format is

detected on the input connector. This indicator does not light when either of the

two internally generated test patterns are selected.

Ref (Reference)

Illuminates green when a reference video signal is present on the Ref In

connector.

Source Select

The currently selected video input will illuminate green.

TBC/Frame Sync

When illuminated green, the TBC/Frame Sync mode is enabled.

Gain

Illuminates green when gain is set to unity or red when gain is other than unity.

Pwr (Power)

Illuminates green when power is applied to the converter and the internal voltage

regulator is functioning correctly.

BrightEye 3 Front Panel

NOTE:

1 2 3 4 5 6 7 8 9 10 11 12 ... 21 22

No comments

Ensemble-designs BrightEye 3 Analog to SDI Converter with TBC and F User Manual Page 7